Our Products
Journeyman 10K3000/6000 MDP4000 FXP3000 XP2500 Manual/Electric1500 Manual/Electric1000 XPTri-Pod KitMan-Hole EXT. KitForce GaugeTugger TalkersRope & AccessoriesWire Grips
Our Company
About UsTestimonialsContactSite Map
More Info
How-ToPrivacy
1500 Manual/Electric
Wire Pulling System
Compact & Lightweight...for "Ease of Use & Fast set-up!
Pull with Confidence!
Porta-Pull's "ALL NEW" Manual or Electric Series Tuggers offer an affordable alternative to expensive and often bulky wire pulling systems.
- 2-Year Warranty
- Uses standard pulling rope.
- Rugged unitized steel frame.
- Complete system-no extra parts to buy.
- Works with any 1/2" cordless or power drill.
- Converts quickly from manual to power drive.
- Heavy duty braking winch for positive rope control.
- Compact, lightweight design carries easily to jobsite.
The most affordable Cable Tugger on the market
P/n 1500M Price...$999.00
Includes 1500M Tugger, 3/4" thru 2" conduit adapters, power drive adapter,
right angle sheave for Operator safety plus Full 2 year warranty on parts and labor
right angle sheave for Operator safety plus Full 2 year warranty on parts and labor
1500M Specifications:
- Weight: 35 pounds
- Maximum extension: 6 feet
- Pulling capacity: 1500 pounds.
- Dimensions: 12" wide x 7" tall x 48" long.
- Pulling Speed: 40 feet per minute w/ drill.
- Conduit Adapters: 1/2" thru 2" included.
1500M |
6 x 4/0 awg cable 250' thru 3 x 90's |
|
Recommended Rope size: 3/8" |
1500 Manual/Electric
Assembly Instructions
- Remove "Puller" and contents from carton.
- Install Winch drum into frame and SECURE with Quick release pin. (Drum gear on right side).
- Now install handle by turning handle clockwise onto Winch shaft spindle.
- Finish by placing head and boom assembly into "Front" of main frame opening as shown in the Illustration at right...and then SECURE boom with the locking pin.
1500 Manual/Electric
Set-up Instructions
Thread desired conduit adapter onto connector as shown in picture. Remove lock nut if more thread is necessary.NOTE: Always install adapter first before fishing rope through conduit! Now insert yoke rod into sleeve of adapter. (Up pull position shown).
IMPORTANT: Please look closely at picture on right.With Drum held in left hand, install 3 or 4 turns of rope around drum starting from bottom of drum and around to top. Set Drum in place and secure with lock pin. Rope must be as shown for correct operation. Bring rope up to and thru rope guide on head assembly.
To use power drive, first remove winch handle by turning counter-clockwise. Remove power nut from rear of unit and thread clockwise onto winch shaft. After installing the power socket into a 1/2" drill, slide socket fully over adapter and operate drill.
NOTE: On heavy pulls, drill should be held firmly when operated.
NOTE: On heavy pulls, drill should be held firmly when operated.
