6000 FXP
3000 FXP
3000 XP
2500 Manual/Electric
1500 Manual/Electric
1000 XP
Tri-Pod Kit
Man-Hole EXT. Kit
Force Gauge
Tugger Talkers
Rope & Accessories
Uni-Grips
About Us
Contact
Site Map
How-To
Privacy
New...Innovative
"UNI~GRIPS"
Wire Pulling System
Product Use-Specifications
and Installation Procedures
Before removing insulation, insure that conductors are cut evenly and that wire is round in appearance. Remove 1 inch of insulation from wire and install Uni-Grip over exposed end.
Using a screwdriver, make a “V” along length of wire. Bring 1 or 2 wire strands back into the V using needle nose pliers. Finish by crimping all wires back together to close the V.
Bring Uni-Grip thru loop of harness and insert steel cables into Uni-Grip slots. Pull forward to tighten. To install ground wire, simply place around large main harness as shown and tape. Caution: Always install ground wire on last Uni~Grip in set.
After completing wire pull, grasp harness at front and work the harness backward to release. Remove harness from Uni-Grip. Cut wire directly behind Uni-Grip and remove insulation. Wire can now be easily removed from tool.
Cable and Wire Tugger System Accessories
CABLE TUGGERS/CABLE PULLERS
MADE IN THE USA